Quested S6R Speakers

Quested S6R Speakers

Quested S6R Speakers

The S6R is the most compact unit in the ranger offering a 5” low frequency driver in an infinite baffle enclosure. The built in amplification provides a total of 110W RMS to the drivers. Power is split with 65W RMS to the 5” LF and 45W RMS to the silk dome tweeter. Attenuation to the input sensitivity along with low and high frequency is available on the rear panel. The frequency response is 80Hz – 20kHz with a +- 2db tolerance and a -6dB cut off at 67Hz. Ideally suited to those with limited space and when coupled to the SB10R offers a very powerful yet compact full range monitoring solution.

Dimensions: 170(w) x 285(h) x 240(d) mm

Weight: 7.5 kg / 15.5 lb

Drivers: Bass cone – 1 x 130 mm (5 ”)

High Frequency: Soft dome – 1 x 28 mm (1 ⅛”)

Maximum SPL: 100 dB continuous pink noise @ 1m. Leq, 1 minuet, single unit. 106 dB continuous pink noise @ 1m. Leq, 1 minuet per pair

Frequency Response: 80 Hz-20 kHz ± 2 dB / 67 Hz-22kHz -6 dB

Connector: XLR and ¼ inch Jack combo socket

Impedance: 10k electronically balanced with RF filters


Pin 1 ground Sleeve
Pin 2 hot Tip
Pin 3 cold Ring

Sensitivity: -12 dBu to +6 dBu for 96 dB SPL @ 1 m set by 10 position rotary switch on rear

Subsonic: -3dB @ 45 Hz, 24dB/oct

Ultrasonic: -3dB @ 75kHz, 4dB/oct

Crossover: 1k19

LF EQ: -2/- 4 @ 82 Hz

HF EQ: +/- 2dB @ 10 kHz

LF output power: 65W RMS continuous (note 1)

HF output power: 45W RMS continuous (note 1)

THD: 0.03% at levels up to 1 dB below clip, 20 Hz-20 kHz. Typ 0.005% @ 1kHz.

Hum & Noise: > -100 dB referred to clip

Note: The continuous rating is for a period not exceeding 5 minutes with unrestricted airflow (100 mm clearance) around the amplifier heatsinks and an ambient temperature not exceeding 30 Degrees C.

Power on: Front mounted green LED indicates power applied.

Clip: Red LED 2 dB before amplifier clip.

Voltage: Set by internal plugs: nominal 115V or 230V @ 50-60 Hz AC 230V setting: min 160V; restricted output power: max 255V 115V setting: min 80V; restricted output power: max 127V

Quiescent: 12W

Typical use: 45W (average music)

Max: 90W (average music)

Note: 0 dBu = 775 mV into open circuit

This product is built to conform to the requirements for CE marking.

Phantom Audio Indonesia
Scroll to Top